ADDED pacesetter long tubes ceramic coated.(1yr old) $300


4L60E(94 LT1) with a 3600vig converter(3 disc lockup). The trans will need rebuit(it still went 10.93 @ 124 the last time the car was driven but it slips on the shift) $400 SOLD

A spohn chassis mounted torque arm w/ drive shaft loop. $275 SOLD


BMR th350/powerglide trans crossmember. (black hammer tone finish looks new) $100 SOLD

Jegs drive shaft loop new and unused $30 SOLD
Eibach drag springs(set of 4) with new sruts and passenger rear bag ready to bolt in. $225

 

Will the loop fit a x pipe setup? If it does I'll take it. PM sent about verter.

Mec

 

ill take the crossmember

 

I will take the eibach kit. just pm me your paypal info and i can send payment.

And is there any chance you will separate the torque arm from the mount?

 

I would say shipping is going to be about $25 on the springs and struts.

So $250 shipped and my paypal is smzjacobs@iowatelecom.net I do not want to seperate the torque arm and mount

 

I never even tried putting this under the car so I'm not sure. .

 

Is the crossmember sold?

Is the price plus shipping?

 

Price plus shipping and or best offer.

 

$230 shipped on T/A & loop?

 

Crossmember is sold

 

t/a and loop?

 

230 shipped is a little low.

Thanks, still for sell.

 

How much for just the stall?

 

You have a pm

 

u have a pm

 

will you separate the stall from the tranny??

 

Here is a picture of the part that mounts to the rear end.

So it will bolt to a 9" and 10 bolt

 

If you want the stall by itself I will go $400 shipped. I know I didn't knock anything off the price but if the stall sells I'll just scrap the tranny no place here to store it.

 

you still have that torque arm?

 

It may be sold. A member asked if he could send the payment tommorrow. So if that doesn't go thru it could be yours.