Patriot 5.3L heads. They have been hand polished and milled .040, They have brand new Patriot Double springs with Titanium retainers and locks. I bought these heads from Jeremy Formato for my original build and now Im doing a forged set-up with a bigger cam and these heads wont work because they have been milled. they will be perfect for a smaller cam set-up (under .600 lift and 234 duration) They were only used on my car for 10 minutes. I will be posting pics soon hopefully if i can get my camera to adapt to my computer.
-SOLD

Harland Sharp 1.8 Roller Rockers- $200

LS1 Intake- $50 obo

Stock LS1 Cam- $30 obo

Stock LS1 Oil Pump- $25 obo

 

negative one trading rating...

 

Yeah a guy gave me a negative trader rating because I made a purchase and the check was bad and I re-sent him one for an extra $25 because of the problem. I was un aware I sent a check with the wrong check book that had been cancelled because my truck was broken into and had checks and cash stolen out of it so I had to cancel that check book. I guess thats what I get for trying to fix the situation

 

If they were milled .04, what are they now, like 57cc??? That's like 12:1 CR on a LS1... I hope they opened the chambers up some.

 

Thats why I am selling them. they do raise the compression to somewhere between 11.5:1 to 12:1 but that wasnt my problem. The main thing was that I was going to run a T-REX cam with them and I dont have enough valve clearance. Thats why they would be perfect for somebody with a smaller cam somewhere in the 220's and low 230's with duration and less than .600 lift. I did have a 234/236 .575 .575 112 and it was fine.

 

where are you located ?

 

Im in Tampa.

 

can you run 12:1 on pump gas??

 

Yeah It works fine. as long as you have somebody that can tune your car. I dont know who does it down your way but I know Formato goes to ft.meyers quite often. these heads were going on a car that I drive everyday and once again, i had clearance issues.

 

I just saw where you have a torquer V1. that cam would be fine with these heads.

 

ttt..

 

ttt..

 

ttt..

 

Come on guys somebodys gotta need some heads. willing to negotiate

 

ttt. NEW PRICE

 

ttt..

 

ttt..

 

do you still have the roller rockers and what condition are they in?