F/S: Heads/ Relocation brackets/ & more....
Thread Starter
11 Second Club
iTrader: (29)
Joined: May 2006
Posts: 1,933
Likes: 1
From: The Bayou State
F/S: Heads/ Relocation brackets/ & more.... This stuff I don't need anymore and cause I'm saving for a 9inch and am only a few hundred $ short. I accept paypal to mpdk_9@yahoo.com, money order's, cash, or trades. If using paypal add 3%. Here goes:
-Stock Torque arm out of a '98 M6. Also at other house. Not damaged at all, but will have pic up soon. Asking $35 shipped
-SLP Loudmouth 1. Also at other house. Will have pics up soon. Had to cut it to get it off. I cut it where it starts going up to go over the axle then had a piece made to make it right again. It still fits as good as before and DOESN'T leak. Asking $200 OBO buyer pays shipping
-Set of 241 heads used. Need to be cleaned up or use your imagination. They have stock springs, but no valves. I'll pay the shipping if asking price is met since there aren't any valves. Asking $120 OBO
PM me with any questions that you may have if I don't get back to you on this thread within the same day of your post. Here's some pics of some of the stuff.
THIS IS THE PIECE I HAD MADE. IT FITS WELL AND DOESN'T LEAK. SYSTEM IS LOOSE RIGHT NOW FOR PICS, BUT A FEW TAPS WITH THE RUBBER MALLET AND IT WILL GO ON FINE. ALL HARDWARE IS INCLUDED.
-Stock Torque arm out of a '98 M6. Also at other house. Not damaged at all, but will have pic up soon. Asking $35 shipped
-SLP Loudmouth 1. Also at other house. Will have pics up soon. Had to cut it to get it off. I cut it where it starts going up to go over the axle then had a piece made to make it right again. It still fits as good as before and DOESN'T leak. Asking $200 OBO buyer pays shipping
-Set of 241 heads used. Need to be cleaned up or use your imagination. They have stock springs, but no valves. I'll pay the shipping if asking price is met since there aren't any valves. Asking $120 OBO
PM me with any questions that you may have if I don't get back to you on this thread within the same day of your post. Here's some pics of some of the stuff.
THIS IS THE PIECE I HAD MADE. IT FITS WELL AND DOESN'T LEAK. SYSTEM IS LOOSE RIGHT NOW FOR PICS, BUT A FEW TAPS WITH THE RUBBER MALLET AND IT WILL GO ON FINE. ALL HARDWARE IS INCLUDED.
Last edited by blue98Z; Feb 26, 2008 at 08:23 PM.
Trending Topics
Thread Starter
11 Second Club
iTrader: (29)
Joined: May 2006
Posts: 1,933
Likes: 1
From: The Bayou State
Not at the moment. Won't have any until Wednesday when I go back to my other house. It's inside my shop. I can PM you or email the pics. I'll also be putting them up on here.
Teching In
Joined: Feb 2008
Posts: 4
Likes: 0
thanks.. may be interested 