FS: 98 LS1 Complete, TH-350, 98-02 Front End, LT1 SS Wing/Hatch, Doors, Wheels, etc..
Thread Starter
Joined: Apr 2002
Posts: 1,840
Likes: 1
From: Dallas, Tejas
FS: 98 LS1 Complete, TH-350, 98-02 Front End, LT1 SS Wing/Hatch, Doors, Wheels, etc.. For sale is a complete LS1 Engine with M6 wiring harness, T1 cam, like new 918 springs with about 1k-2k on them, coil packs, intake, heads, belt driven accessories, working A/C, etc. Including K-member with Complete suspension- stock, brakes, and including rack n pinion.
(purchased from member "Josh McGrath" installed it but never ran, never completed the install or swap to our car)
T1 Cam Specs: http://ourworld.cs.com/jrp98ls1/T1+cam+card.jpg
*SOLD!*
Front body is off a 2001 Camaro Z28. Has some scratches on front so needs to be painted. Included is the stock Z28 hood, fenders, bumper, headlights, brackets, and fog lights (not pictured).
*SOLD!*
93-97 Camaro SS wing/spoiler. Bought this LT1 Camaro SS wing from a member a while back. Spray painted it flat black but its in good condition, just needs to be painted. Hatch available as well, glass and shocks. Fits 93-02 Camaro
*SOLD!*
2000 F-body T-tops with grey plastic, factory tint.
*SOLD!*
93-02 Camaro Pass. Side Door. Door, Glass, and motor only, no mirror, no interior panel.
SOLD!
93-02 Camaro Rear Bumper, just needs to be painted.
SOLD!
93-96 Camaro rear taillights. Good condition. Both driver and passenger available. Also have an extra passenger side taillight. Fits 93-02 Camaro
*SOLD!*
(3) Chrome LT1 Camaro wheels (1) silver wheel, some minor curb rash. No tires.
SOLD!
I traded a 6-speed for this TH350 a while back from a member here. Had it running on my 30th TA for about 8,000 miles then took it out cause I sold the engine. So it was working then. All I still remember is that the 1st gear is similar ratio to that of a 4l60e or something. Dont really know what all was done to it. Its been sitting in garage for a while now and never used it again. Unfortunatly, I discovered a huge crack on the casing in what is considered the bellhousing. It looks bad and I think what happed is that someone just jbwelded it or glued it and painted it so it couldnt be seen. Looks repairable. Maybe $60 to have it welded. Comes with stock TH350 torque converter, correct tailshaft and adapter for LS1 F-body length, modified x-member (M6 with plate) for direct fit on F-body, flexplate with adapter and bolts, transmission cooler, brand new summit aluminum oil pan, new oil filter and gaskets, and B&M megashifter with cable. Shifter can be cleaned and polished up again
SOLD!
(purchased from member "Josh McGrath" installed it but never ran, never completed the install or swap to our car)
T1 Cam Specs: http://ourworld.cs.com/jrp98ls1/T1+cam+card.jpg
*SOLD!*
Front body is off a 2001 Camaro Z28. Has some scratches on front so needs to be painted. Included is the stock Z28 hood, fenders, bumper, headlights, brackets, and fog lights (not pictured).
*SOLD!*
93-97 Camaro SS wing/spoiler. Bought this LT1 Camaro SS wing from a member a while back. Spray painted it flat black but its in good condition, just needs to be painted. Hatch available as well, glass and shocks. Fits 93-02 Camaro
*SOLD!*
2000 F-body T-tops with grey plastic, factory tint.
*SOLD!*
93-02 Camaro Pass. Side Door. Door, Glass, and motor only, no mirror, no interior panel.
SOLD!
93-02 Camaro Rear Bumper, just needs to be painted.
SOLD!
93-96 Camaro rear taillights. Good condition. Both driver and passenger available. Also have an extra passenger side taillight. Fits 93-02 Camaro
*SOLD!*
(3) Chrome LT1 Camaro wheels (1) silver wheel, some minor curb rash. No tires.
SOLD!
I traded a 6-speed for this TH350 a while back from a member here. Had it running on my 30th TA for about 8,000 miles then took it out cause I sold the engine. So it was working then. All I still remember is that the 1st gear is similar ratio to that of a 4l60e or something. Dont really know what all was done to it. Its been sitting in garage for a while now and never used it again. Unfortunatly, I discovered a huge crack on the casing in what is considered the bellhousing. It looks bad and I think what happed is that someone just jbwelded it or glued it and painted it so it couldnt be seen. Looks repairable. Maybe $60 to have it welded. Comes with stock TH350 torque converter, correct tailshaft and adapter for LS1 F-body length, modified x-member (M6 with plate) for direct fit on F-body, flexplate with adapter and bolts, transmission cooler, brand new summit aluminum oil pan, new oil filter and gaskets, and B&M megashifter with cable. Shifter can be cleaned and polished up again
SOLD!
Last edited by Dirty 30; Feb 24, 2008 at 01:22 AM. Reason: Shit Sold
Trending Topics
Thread Starter
Joined: Apr 2002
Posts: 1,840
Likes: 1
From: Dallas, Tejas
Thread Starter
Joined: Apr 2002
Posts: 1,840
Likes: 1
From: Dallas, Tejas
Thread Starter
Joined: Apr 2002
Posts: 1,840
Likes: 1
From: Dallas, Tejas
Oh you meant the Trans Am. Yeah we still have it at my sisters house lol. Been too lazy to get it out. I think we are just gonna give the title and car to a tow truck so they can pick it up and sell it for scrap. If not I might post it on craigslist.
