New CTS-V oilpan. Only used for fitment mock-up. Mint condition. Comes with gasket, pickup, baffle and pickup o-ring. You may need windage tray. Truck windage tray fits fine with this pan. Stock truck dipstick also worked fine. I decided to use an aftermarket Moroso oil pan, so I need to sell this one. Price of this pan and pickup from Scoggins-Dickey is $306.00. I'll sell this for $225 shipping included.



2004 4.8L Truck oilpan and pickup. Off engine with 40k miles. $80 Shipped.



Email me for pictures or questions at phillip@maliburacing.com. Items shipping from Huntsville, AL.



Thanks.

 

ttt. Thanks for looking.

 

could you e-mail pictures to r_d_butler@sbcglobal.net

 

Need to sell these guys, lower prices:
NEW CTS-V pan/gasket/pickup: $200 shipped
Used Truck pan with used gasket and pickup: $60 shipped.

Need the money to finish my father/son project.

Pictures below:

CTS-V Pan:


CTS-V Pan on left, truck pan on right:


Truck pan on left, CTS-V pan on right:

 

You have a PM.

 

Did the mock up work? Did you have any clearence issues with the frame or the ground clearance?

 

Would you want to trade for a NEW LH8 (Hummer, colorado) pan? has baffles and pickups

 

I dropped you a PM yesterday. Jeff

 

Sent a PM offering full asking price -- only asked that you respond as to whether we had a deal or not.

Would like to have your CTS-V pan. If not available would also appreciate the courtesy of a response so I am free to "move on " to another seller.

Eighteen hours have elapsed since PM sent -- did you not receive the PM?

Best regards,
Jon Lewis

 

pillboxesghost, response sent. Sorry for the delay, I don't surf here regularly. If still interested, it's yours.

t72ss402: I did not get it fully installed, meaning that I did not have the transmission bolted to it and mounted. Just going by the initial "fitment" of dropping the motor only into place, it looks like it would work fine. It appears that it would be either flush with the crossmember or hang below at most 1/2", depending on the tilt when the transmission was bolted into place. When the motor was sitting level, it was slightly above the crossmember. I've been told they fit the earlier A-bodies fine, but don't know that for sure.

Thanks,

 

Sent PM confirming I would take pan & pick-up tube.
Details on payment were included.

Thanks for selling me the pan!

Jon Lewis

 

Sell pending (pillboxesghost) on CTS-V pan.

Truck pan still available!

 

CTS-V pan Sold.