All prices shipped (at least in the lower 48) and I do accept paypal. If needed I'd be happy to take photos of anything you'd like, it's just quicker to make this FS post without them. everything is used unless noted otherwise.

Patriot Dual Gold Springs, Ti Retainers, New Valve Seals, New Seats, Keepers. - SOLD

Z51 Front 2002 28.6mm Swaybar (no endlinks/bushings) - $55 shipped

Stock Throttle Body with Electronics - $70 shipped

New C6 Thermostat - $10

C5 Drive Belt Tensioner with Pulley - SOLD

Motorad 180deg Thermostat from LGM - $20 shipped

OEM Header Gaskets - $10

OEM Brake Caliper Pistons - $20 Shipped

LS1 Valley Cover with Gasket - SOLD

Front Center Skid Plate (needs some mild work to straighten) - $20

MSD 8.5mm Plug Wires (used about 20k) - SOLD

Duralast Plug wire Set (used about 20 miles (not 20k)) Honestly Very Nice Wires - $20 shipped

2002 2-Piece Oil Pan with Pickup - SOLD

AMW Catch Can - Silver with Bracket - SOLD

 

you selling the 224 cam?

 

No, it's still in the engine. I like that little cam.

 

Are those MSD wires off of a Vette or camaro?? Are they interchangeable?

 

They will work for both Vette and Camaro without issue.

 

Springs Sold

 

would you happen to know the model number on the wires? any pics? do you take paypal?

 

No idea of the model number, but I doubt there are too many 8.5mm MSD wires for the LS1. Below is a pic of them. Lots of interest but nobody has pulled the trigger on them.

 

I'll take them. Can you shoot me a paypal request to calstud86@aol.com?

 

The tensioner and wires are sold.

 

Bump, lots of items still FS

 

Still a lot of parts FS.

 

Added AMW catch can with bracket.

 

Feel free to make an offer on anything. I'd just like to get things sold.

 

Got pics of the skid plate? I need one to cut up for a project.. hehe Trying to see how bad it needs to be straightened...

Thanks
Steve

 

This is the worst angle I could get.

 

Vette or FBody pan?

 

Vette LS1 pan.

 

oil pan sold

 

Still many items remaining.