I have a LS1 Aluminum Driveshaft from a 2001 Camaro SS M6 w/ 24k miles......has a new 1350 U-joint....will work with 9in or you can swap out u-joint......$120 shipped

Selling because I am upgrading to a PST shaft so I don't have problems

 

only 24k on it? was it off your camaro? shoot me a pic of the odometer please. why did you replace the U-joint on it?

pm me please

 

Yes it was on my SOM Camaro SS in my sig......Putting in forged motor so the wiring harness is not connected to the car but if you are seriously interested I will sent you a pic of the odometer in the next day or two when I have the car back together......the odometer is between 24-25k

I replaced the u-joint because I bought a 9in moser axle....then 100 miles later I started getting the motor forged and have not used the shaft since

 

You have a PM

 

pm sent

 

is there any et drop for the quarter mile over a steel shaft?
I replaced the shaft with alum. in my previous camaro and didn't notice any et changes but the car was tons smoother at higher speeds...

 

have no idea......it is less rotating mass though, so it might

 

$100 shipped? let me know

 

bump....ttt

 

how about today??? will call you would like to come in morn...

 

Sold!!!

 

Thanks again, I got my fingers crossed hope it is just the DS and not something else. Can't wait to see your ride finished.......... I know you can't.