ALL PARTS ARE NEW AND NEVER USED!!!!


Promaster starter Cost me $150
Asking $75

Eagle Crankshaft Cost me $630
Asking $425

Eagle H beam rods w/arp bolts cost me $540
Asking $350

Dart Iron Heads Paid SOLD

350 bored 40 over 4 bolt bare block paid $450
Asking $250


TCI Street Fighter 3500 stall SOLD



WILLING TO TRADE FOR LS PARTS as listed....
NW90mm TB
UMI K member
XTREME Rear Anti-Roll Bar


Crankshaft info

Part number: ESP-435034806000

Rear Main Seal Style: 2-piece
Engine Stroke (in): 3.480 in.
Crankshaft Material: Forged steel
Engine Balance: Internal
Lightened: No
Requires Narrow Bearings: Yes
Rod Bearings Included: No
Main Bearings Included: No
Cross-Drilled Mains: No
Rod Journal Diameter (in): 2.100 in.
Main Journal Diameter (in): 2.449 in.
Balancer Bolt Thread Size: 7/16-20 in.
Crankshaft Snout Style: Standard

H beam rods info

Part number: ESP-6000B3DL19

Connecting Rod Length Center To Center (in): 6.000 in.
Connecting Rod Beam Style: H-beam
Connecting Rod Material: Forged 4340 steel
Connecting Rod Finish: Shot-peened
Wrist Pin Style: Floating
Clearanced for Stroker: No
Cap Retention Style: Cap screw
Connecting Rod Bolt Brand: ARP
Connecting Rod Bolt Diameter: 7/16 in.
Connecting Rod Bolt Material: L19 alloy
Fastener Yield Strength (psi): 200,000 psi
Connecting Rod Bolt Head Style: 12-point
Pressurized Pin Oiling: No
Approximate Connecting Rod Weight (g): 645
Big End Bore Diameter (in): 2.100 in.
Pin End Bore Diameter (in): 0.927 in.
Advertised Horsepower Rating (hp): 700 hp
Advertised RPM Rating: 7,500 rpm
Weight Matched Set: Yes
Remanufactured: No
Balanced: No
Magnafluxed: Yes

 

 

T T T

 

T T T

 

Bump!

 

Pics of tranny/stall? Any miles put on it since rebuild?

 

I dont have any pics right now and it will be a while before I can get any. There are no miles on any of the parts I have listed.

 

Does the tranny have the 6" or 9" tail shaft? What kind of parts went in to the tranny, what will it hold? Also, can you / will you ship to 89128. thanks

 

All parts still for sale

 

damn. i wish i would have ran across this sale a year ago when i was buying the short block for my build. good luck to you man. if any of my buddies are looking for a simular build i'll throw them your way.

 

Ttt!!!

 

Bump!

 

I can get you $300 for the converter if youre intersted

 

Bump!

 

T t t !!!

 

Bump!!!

 

BUMP!!!! Willing to take offers

 

Still have the transmission?

 

transmission is gone. Sold it a few weeks ago