HUD in a Camaro
#1
HUD in a Camaro
Well it seems its a bit closer....take notice that in the article the guy who did the install, in a vette, didn't have the special glass. The tricky part seems to be how to modify the dash to accept the unit and the controls....
So..its not impossible
http://joshker99.home.comcast.net/hudinstall2.htm
So..its not impossible
The factory HUD cars have a special HUD windshield that is not necessary as the projections shown above are taken on my non-HUD glass in direct sunlight.
http://joshker99.home.comcast.net/hudinstall2.htm
#2
MOre Info
http://members.***.net/corvette/hud.htm
COST ISSUES
From GM Parts Direct you can buy a projector for about $300 including shipping.
A dimmer switch is $75 including shipping
A bezel is about $16 plus shipping.
The 11 pin harness is only custom made & not for sale from GM. Try
searching corvetteforum.com for people who make them if needed.
It is also recommend that you buy or borrow a dremel with a right angle.
That will cost around $100.
http://members.***.net/corvette/hud.htm
COST ISSUES
From GM Parts Direct you can buy a projector for about $300 including shipping.
A dimmer switch is $75 including shipping
A bezel is about $16 plus shipping.
The 11 pin harness is only custom made & not for sale from GM. Try
searching corvetteforum.com for people who make them if needed.
It is also recommend that you buy or borrow a dremel with a right angle.
That will cost around $100.
#3
TECH Fanatic
iTrader: (8)
Join Date: Oct 2005
Location: Fort Washington Pa
Posts: 1,854
Likes: 0
Received 0 Likes
on
0 Posts
I know it's a whole different car and setup but here is a clever and pretty low cost build I found.
http://www.honda-tech.com/zerothread?id=1436211
Don't cry because it's a Honda site, this is a clever idea that could work for camaros as well
http://www.honda-tech.com/zerothread?id=1436211
Don't cry because it's a Honda site, this is a clever idea that could work for camaros as well
Trending Topics
#8
TECH Resident
iTrader: (12)
Join Date: Jan 2006
Location: TX
Posts: 863
Likes: 0
Received 0 Likes
on
0 Posts
any luck installing this in an f-body? i was thinking of getting a late bonneville HUD control for the trans am dash and putting it where the TCS switch usually is (custom fab) and using it with the z06 hud. possible?