I have the following for sale in Atlanta, GA. The stock parts came off my 1998 Z28 with 75K miles.

used stock LS1 aluminum drive shaft. Sold to TXmaro, Thanks!

Aluminum driveshaft

Used stock 10-bolt axles with the exciter rings for 4 channel abs/tcs. $60 for both plus shipping

Axles PIC 1

Axles PIC 2

Used (15K miles) LS1 Spec 3 pressure plate, w/ Spec 3 ceramic clutch disk, and flywheel. The clutch never slipped and was never tracked. It did chatter. Sold to 02LsGuN19, Thanks!

SPEC 3 PIC 1

Flywheel

Clutch disk

SPEC 3 PIC 2

 

has the flywheel ever been resurfaced and how much would shipping be to 71854?

 

PM sent

 

Hey man, I'm interested in these:

Used stock 10-bolt axles with the exciter rings for 4 channel abs/tcs. $50 for both plus shipping

Are both axles in good shape (no pitting, damage on bearing seat, etc.)? Were they quiet when you took them out? Reason for pulling them out?

I need one of these, but would gladly take both for $50 + shipping if they're in good shape. On that note, willing to meet halfway to avoid shipping (I live in N. Alabama, so I could come down 75 and meet you in the middle)?

Just let me know.

PM sent btw.

Thanks!

 

The flywheel has never been resurfaced. I bought the SPEC III new with the new flywheel. The shipping is around $45 to 71854 through the USPS w/ Priority Mail (2-day) and Delivery Confirmation.

 

Sent you a PM.

 

I want it so will you send me the adress please and I will ship the money. Thank you, Doc

 

PM Sent

 

02LsGuN19 and XtrmLS1spd, you both have a PM back.

 

Does the driveshaft come with the yoke and u-joints if so how much to ship to 26164.

I'll be off the net till monday. I'll check back then.
Thanks

 

You are 3rd on the list for the drive shaft. It comes ready to bolt up. I went with a new driveshaft with the 1350 u-joint for my new 9". I didn't want to mess with pressing on a u-joint conversion on the stock drive shaft. The shippping is $25.