!!! 
Oh No!! Not another Camaro Wide Body Thread!
http://cgi.ebay.com/ebaymotors/Chevy...QQcmdZViewItem A quick search found another. Nice work man, keep it up.
I like everything but the rear lip in the wheel well. it is like 2" If there was a way to mod the stock fender before the panel goes on then I would be all over this. Also a Sunoco hood and those front bumper splitters! I am running 17x10 front and 17x11 rear but have matching 17x12 (335/35/17) I would love to run.
All this makes the hours I spent in the garage in the middle of the night trying to fugure out "How the Fu%$ do I make this work!" worth it. What? That I am trying to have these remade in urethane but at the very least hope to offer then in fiberglass and will try to put mod days together where we send McNord around the country to widebody your cars?
I don't know what you're talking about...
I don't know what you're talking about...
TECH Apprentice
Joined: Jul 2003
Posts: 346
Likes: 0
From: Raleigh, NC
If you produce a good quality wide body kit, count me in! I have been eyeballing your splitter and may be purchasing one soon. Good work on the splitter!
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
I'll have the SixLiterEaterSplitterWiderCenterExhaust & Targa mod.
That's what you need to be doing. Klumzyee (Eric) used to do that and still does that in some instances when he's gathering interest for certain products. I remember throwing around the idea of $100 or $50 deposits when he was going to make the CME valances. People quickly shut that idea down though. He's a good guy to work with and he also works with a lot of fiberglass and poly manufacturers so you can get almost anything you want done right.
TECH Apprentice
Joined: Jul 2003
Posts: 346
Likes: 0
From: Raleigh, NC
any chance you could take some pictures of the edges along the door, and how it fades under the sail panel? im planning on building a widebody for the ta once i finish moving, and theres a few things im still not sure on how to go about doing.
