custom b-m shifter for 4l80e
Thread Starter
Launching!
Joined: Jan 2008
Posts: 238
Likes: 0
From: AUSTRALIA
Yes it is the quicksilver , the red indicator works i had to make several bracket with pins and rods , that part took me almost 1 day, also the unit had to be droped below the floor and then i had to make a fiberglass cover for heat and noise . you have to mount assemble then dummy assemble until its right . the gage indicator is the hardest.
On The Tree
Joined: Jun 2007
Posts: 128
Likes: 0
Yes it is the quicksilver , the red indicator works i had to make several bracket with pins and rods , that part took me almost 1 day, also the unit had to be droped below the floor and then i had to make a fiberglass cover for heat and noise . you have to mount assemble then dummy assemble until its right . the gage indicator is the hardest.
i was thinking of cutting and shortening the shifter handle to make it fit.
How many inches did you drop it?
cheers
Trending Topics
Thread Starter
Launching!
Joined: Jan 2008
Posts: 238
Likes: 0
From: AUSTRALIA
The only reason i went with the Quick silver unit is because it looks neat and tidy . I dont want to be harassed by the police . I could of used other units but being a street car i would be worser off especially when asked to remove it
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo Thread Starter
Launching!
Joined: Jan 2008
Posts: 238
Likes: 0
From: AUSTRALIA
If i remember right you will have issues when u drop down gears to low not enough room to set braket for gear selecter . I think i sunk it about 2 inches . First i mounted a ali plate and roughly traced the shape , then you need to place the console and top plate , remove and assemble and cut out in stages .
