To the guys at Race Proven Motorsports
< setup >
TFS 225's milled
Ported FAST 92mm
Ported stock throttle body
RPM'3 camshaft < leaving out specs for Fran to tell.

U/D pulley
OTHER supporting hardware
car was tuned using a Mustang Dyno.
It put down 482rwhp and 424rwtq
Thanks again guys.
Fran feel free to chime in.
Last edited by gpedrick; Nov 8, 2008 at 12:39 PM.
< setup >
TFS 225's milled
Ported FAST 92mm
Ported stock throttle body
RPM'3 camshaft < leaving out specs for Fran to tell.

U/D pulley
OTHER supporting hardware
car was tuned using a Mustang Dyno.
It put down 482rwhp and 424rwtq
Thanks again guys.
Fran feel free to chime in.
I read this on LS1GTO. Congrats on your setup bro
I went with the RPM-2 cam /Vengeance ported Fast/unmilled TFS 225 because I am afraid of any possible detanation. Check out my graph of before and after. Here is camonly and then heads/cam/fast. Congrats on your setup I bet that pulls like hell up top. Tell me how you like my setups TQ curve!!
http://www.ls1gto.com/forums/attachm...3&d=1225308647
and a vid http://www.youtube.com/watch?v=zjnzjIUDonI
Trending Topics
I went with the RPM-2 cam /Vengeance ported Fast/unmilled TFS 225 because I am afraid of any possible detanation. Check out my graph of before and after. Here is camonly and then heads/cam/fast. Congrats on your setup I bet that pulls like hell up top. Tell me how you like my setups TQ curve!!
http://www.ls1gto.com/forums/attachm...3&d=1225308647
and a vid http://www.youtube.com/watch?v=zjnzjIUDonI
Last edited by gpedrick; Nov 22, 2008 at 03:49 AM.
The Best V8 Stories One Small Block at Time
http://www.youtube.com/watch?v=Tdx3pkEKgzI
Sounds mean Fran!!!
I am coming back to the state's in a few weeks though
!!! I have Kooks 1 3/4 WO cats and a Bassani Catback. I am still on the fence on what to do next. I am gonna get the Harrop diff cover and Pedder 5/8 inch rear raise springs. And Im JohnWins over there


