LS1 - truck manifold Cross over pipe for T6 turbo setup
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
This is exactly what i'm looking for. Do you have any installed pics? What radiator setup would I need? It's tough to tell from the pics but the turbo looks really high. Does it interfer with the water pump or intake at all?
the turbo sits in front of the crank pulley and in front of the water pump pulley. it does sit a little higher to allow for proper oil drain and you will need to modify your radiator to fit( fold verticle) but it does not hit any of the motor components, it sits 1/2 away from said components.
as far as pics, i dont have any of them in the vehicle
as far as pics, i dont have any of them in the vehicle
you need a BMR turbo K member.
you cant fit a 4" through the stock K member without at least soild mounts. even then, THIS downpipe setup is made for a BMR turbo K member. stock is not applicable in this application.
you cant fit a 4" through the stock K member without at least soild mounts. even then, THIS downpipe setup is made for a BMR turbo K member. stock is not applicable in this application.