6 speed swap
Thread Starter
11 Second Club
iTrader: (18)
Joined: Apr 2006
Posts: 447
Likes: 1
From: Ford City, PA
6 speed swap Almost everything you need to swap in a 6 speed.
Included is:
GM Bell housing
T-56 Transmission
Crossmember
Stock Shifter
All the hydraulic lines
Clutch resevoir
Master cylinder
Pedals
Upper Shift boot (the one that attatches to the console). It is Ebony and has one crack in the plastic retaining ring.
All you need is a clutch to fit your application, a slave cylinder, and the upper console and you're set!
Transmission originally came out of a 2000 Camaro SS. I then put it in my 97 Camaro when I did my LS1 swap. I had it for a year and now I no longer need it. Everything has a total of 105K miles on it. Transmission generally worked fine (very seldomly did it grind 5th).
$1500
Will do trades/trades+cash for the following parts:
Victor Jr for L92 heads
60# injectors (must be new)
4l80e
Kooks 2" primary headers
I also have a Denny's Nitrous Ready driveshaft that is the correct length for this with a Moser 9" with 1350 u-joints, that I can throw in for an extra cost.
Additional note I will seperate if I have a buyer for the transmission
That being said I'm located in Kittanning, PA, which is about 45 miles northeast of Pittsburgh, PA.
Included is:
GM Bell housing
T-56 Transmission
Crossmember
Stock Shifter
All the hydraulic lines
Clutch resevoir
Master cylinder
Pedals
Upper Shift boot (the one that attatches to the console). It is Ebony and has one crack in the plastic retaining ring.
All you need is a clutch to fit your application, a slave cylinder, and the upper console and you're set!
Transmission originally came out of a 2000 Camaro SS. I then put it in my 97 Camaro when I did my LS1 swap. I had it for a year and now I no longer need it. Everything has a total of 105K miles on it. Transmission generally worked fine (very seldomly did it grind 5th).
$1500
Will do trades/trades+cash for the following parts:
Victor Jr for L92 heads
60# injectors (must be new)
4l80e
Kooks 2" primary headers
I also have a Denny's Nitrous Ready driveshaft that is the correct length for this with a Moser 9" with 1350 u-joints, that I can throw in for an extra cost.
Additional note I will seperate if I have a buyer for the transmission
That being said I'm located in Kittanning, PA, which is about 45 miles northeast of Pittsburgh, PA.
Last edited by danhr; Sep 19, 2009 at 03:30 PM.
