What gears would be the best?
I hope you're not referring to me, because if you are, you obviously can't read. I clearly stated that I have installed, tested, and removed 3.91's from my car. For some reason, my setup seams to prefer the 3.46's. The car picked up more with the FAST then it did with the gears for roughly the same investment.
What size tire are you running though? Most of us are still running a 26ish inch tall tire, which would make 4.56's really suck on the highway. Looks like you ought to be in the 10's pretty easy now.
Staging Lane
Joined: Nov 2008
Posts: 86
Likes: 0
From: fort wayne,indiana
i also run 4.56's and they are not bad on the highway at all. i get over 20mpg on the highway still, but it is around town it is in the single digits.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo i was running a 28 and now going to a 29.5 tall. but i do my own installs and gears are cheap for a 9"
Thread Starter
Launching!
Joined: May 2009
Posts: 283
Likes: 0
From: DFW,TX
Thats good. Javier wrecked his Goat so hes parting it out and I'm picking up his ported Fast 90 intake manifold. Should push me over the 400rwhp mark!
Thread Starter
Launching!
Joined: May 2009
Posts: 283
Likes: 0
From: DFW,TX
Not sure. I have to buy a bigger throttle body to go with it. Once I sell my Ls6 intake manifold then I can buy that. I'm also at 92% on my injectors so I might wait to do all of that at once. I just didn't want to pass up on this awesome deal.
Thread Starter
Launching!
Joined: May 2009
Posts: 283
Likes: 0
From: DFW,TX
You going to beach this sat?
I have a lot more power than you, and I'm an M6 and with 3.91's or 4.10's I'd be just about at the top of 4th at the end of the 1/4. PLUS I get 27 MPG on the highway with 3.73's.
3.73's are more than enough for any decently modded setup..with a cam and high revving combo they like to stay in the gear a little bit more......go with 3.91's if you're not planning on doing a **** ton to the motor and need to get the most out of a weaker engine with slicks and traction.
3.73's are more than enough for any decently modded setup..with a cam and high revving combo they like to stay in the gear a little bit more......go with 3.91's if you're not planning on doing a **** ton to the motor and need to get the most out of a weaker engine with slicks and traction.