BMR Springs, before and after pics!
Thanks for posting up some pics. The car looks great.
TECH Addict
Joined: Dec 2001
Posts: 2,907
Likes: 1
From: Bergen County, NJ
Mine are RR 27 1/4 LR 27 1/2
RF 26 1/2 LF 26 5/8
I had to shim them to get the height I wanted with a little bit of a rake to front so when I go for replacements this winter I was hoping to get something with the same (or nearly) height.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo whats the tire combo on your car?
springs and monroe shocks from oreillys is all i did.
pretty stiff, little bounce, but overall a good ride. havent rode in another lowered f-body so i couldnt tell you how it would compare. but a lot stiffer than stock.
pretty stiff, little bounce, but overall a good ride. havent rode in another lowered f-body so i couldnt tell you how it would compare. but a lot stiffer than stock.
I always heard lowered F-Bodies ride like ****. I really want to lower my car but I don't want it to be a hard, bouncy ride from hell. I rode in an SRT-4 Neon with Eibach lowering springs and every bump we went over the car felt like it was going to snap in half. Ride was HARD and I do not want that.
I always heard lowered F-Bodies ride like ****. I really want to lower my car but I don't want it to be a hard, bouncy ride from hell. I rode in an SRT-4 Neon with Eibach lowering springs and every bump we went over the car felt like it was going to snap in half. Ride was HARD and I do not want that.
Same here. I will be installing my Konis this weekend and been debating going with the stock springs or getting lowering springs from BMR or Strano.
If you decide to go with ours give me a call. Don't forget our springs are guaranteed for life against spring sag. We have them in stock and we can ship them out same day if ordered by 3pm est. If you have any questions please give me a call.
I like the stance of the car as well, Would it be dumb to lower just the front??? I really don't think that the back looks bad how it is but the front always has a hell of a gap between the tire and fender. I swapped out my rear shocks with some bilsteins because mine where shot and making all kinds of noises over ever bump but didn't swap the front shocks or any springs. I would like to run 26.5 tall tires in the back and some skinnies up front so i would like to keep the back as is but yet install some new springs all the way around lowering the front an 1 and half inch to take that gap out. How would this affect the ride. I have all adjustable BMR suspension so would I have to adjust for this type setup?
