HELP Oil pressure problems
HELP Oil pressure problems I am on a fresh rebuilt 99 ls1. Drove the car for 3 days and oil pressure was slowly decreasing. Got down to about 10psi hot at idle on a mechanical gauge so pulled the oil pan and front cover off. Replaced oil pump with a new ls6 ported oil pump, and replaced the cam retaining plate and new o-ring. I checked all the bearings and they checked out great, pulled the cam and checked the cam bearings and they were ok.
Got engine all back together and have 10psi at idle still. Bottom end is quiet but the valvetrain is a little noisy. I am stuck and need some ideas. Please help!!
Got engine all back together and have 10psi at idle still. Bottom end is quiet but the valvetrain is a little noisy. I am stuck and need some ideas. Please help!!
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo Man thats a tuff one, Sounds like everything is in check so it shouldnt be runing that low. It couldnt be just be a bad gauge could it? have you tried another gauge. Do mechanical gauges work directly in place of the stock sending units? im sure they do I just dont know. FYI I had an ls1 that wasnt put together right and was getting 10psi when hot and only drove it 200 miles befor looking into it. by that time it had ravished the cam and other bearings. 10psi is to low for that engine. If you say your bearings are good and there is no metal shavings in the oil id say that your oil pressure has to be higher than what its saying.
check the oil gallery freeze plug, on the front of the motor under the timing cover, when i finished putting on my oil pump the other day, before i bolted up the timing cover, i decided to crank the engine till oil psi goes up, and it did, while cranking it hit 45 psi. then i looked closely to see if any oil will bleed off from the pick up tube o ring, and i guess mine was ok, no oil. but my dad also made me a girdle to slide over the pick up tube, i think that helped alot, alot safe and secure seal. i also used assembly lube in the pump and that created like a suction for the oil to build psi up faster
