That paint is pimp! 
.....LOL 
1998 Twin Turbo Cobra Convertable FS/FT
Thread Starter
10 Second Club
iTrader: (4)
Joined: Aug 2006
Posts: 146
Likes: 0
From: macclenny florida
1998 Twin Turbo Cobra Convertable FS/FT Forsale, 1998 Cobra Twin Turbo, 75.000 miles on the clock, 5-Speed.
Car had been in an Accident when I purchased it about Three months ago, The pervious owner had it stored in his Garage when a drunk driver run into his house and into the garage Damaging the car on the driver side, I have replaced the drivers side Fender, Door, and Rear Quarter Panel, There was no structural damage under these panels so it was a pretty simple fix. There was also minor damage to the passenger side Fender and Door that has also been repaired.
MODS
HP Twin Turbo Kit
57 MM turbo up grade
Tial Waste Gate up grade
Tubular K-Member
Tubular Upper & Lower Control Arms
QA1 Caster/Camber Plates
QA1 Coilovers Front and Rear
MMR short block: Bore 3.552, Manley 18cc Dish 2618 Platinum Coated Pistons, ARP Stud Kit, Iron Block Good to 900 HP
Stage 1 Port Job
High Performance Springs
Fast 83LB Injectors
Complete Aeromotive Fuel System With Twin Pumps
MSD DIS 4 Ignition
MSD Tach Adapter
MSD 8.5 Plug Wires
MSD Blaster Coils
White Face Fuel and Boost Gauges
HBC Manuel Boost Controller
Mcleod Street Twin Clutch
PRO 5.0 Shifter
Built 8.8 Rear with 3.73 Gears
2.5” Catback H-Pipe Dynomac Muffler
Snow Performance Meth Injection
Car made 661/663 RWHP on pump gas at 17 PSI
I’m sure there are some things I missed, I have $18,000 in Receipts
Thing I know the car needs, Final Sanding and Paint, New Top, Bushings in Rear Lower control Arms
$18,000 OR TRADE
I will add Pics and Dyno Sheet this afternoon....thanks Mike
__________________
Car had been in an Accident when I purchased it about Three months ago, The pervious owner had it stored in his Garage when a drunk driver run into his house and into the garage Damaging the car on the driver side, I have replaced the drivers side Fender, Door, and Rear Quarter Panel, There was no structural damage under these panels so it was a pretty simple fix. There was also minor damage to the passenger side Fender and Door that has also been repaired.
MODS
HP Twin Turbo Kit
57 MM turbo up grade
Tial Waste Gate up grade
Tubular K-Member
Tubular Upper & Lower Control Arms
QA1 Caster/Camber Plates
QA1 Coilovers Front and Rear
MMR short block: Bore 3.552, Manley 18cc Dish 2618 Platinum Coated Pistons, ARP Stud Kit, Iron Block Good to 900 HP
Stage 1 Port Job
High Performance Springs
Fast 83LB Injectors
Complete Aeromotive Fuel System With Twin Pumps
MSD DIS 4 Ignition
MSD Tach Adapter
MSD 8.5 Plug Wires
MSD Blaster Coils
White Face Fuel and Boost Gauges
HBC Manuel Boost Controller
Mcleod Street Twin Clutch
PRO 5.0 Shifter
Built 8.8 Rear with 3.73 Gears
2.5” Catback H-Pipe Dynomac Muffler
Snow Performance Meth Injection
Car made 661/663 RWHP on pump gas at 17 PSI
I’m sure there are some things I missed, I have $18,000 in Receipts
Thing I know the car needs, Final Sanding and Paint, New Top, Bushings in Rear Lower control Arms
$18,000 OR TRADE
I will add Pics and Dyno Sheet this afternoon....thanks Mike
__________________
Last edited by vigalante LT1; Sep 24, 2007 at 06:20 PM.
Paint it? No way, go cruising looking for trouble with it like that. Who would take a Cobra that is 5 colors serious, then blow some doors off.
Good luck with the sale, must be a fun Mustang.
Good luck with the sale, must be a fun Mustang.
Launching!
Joined: Jun 2007
Posts: 274
Likes: 0
From: auburn, california
Originally Posted by vigalante LT1
Forsale, 1998 Cobra Twin Turbo, 75.000 miles on the clock, 5-Speed.
Car had been in an Accident when I purchased it about Three months ago, The pervious owner had it stored in his Garage when a drunk driver run into his house and into the garage Damaging the car on the driver side, I have replaced the drivers side Fender, Door, and Rear Quarter Panel, There was no structural damage under these panels so it was a pretty simple fix. There was also minor damage to the passenger side Fender and Door that has also been repaired.
MODS
HP Twin Turbo Kit
57 MM turbo up grade
Tial Waste Gate up grade
Tubular K-Member
Tubular Upper & Lower Control Arms
QA1 Caster/Camber Plates
QA1 Coilovers Front and Rear
MMR short block: Bore 3.552, Manley 18cc Dish 2618 Platinum Coated Pistons, ARP Stud Kit, Iron Block Good to 900 HP
Stage 1 Port Job
High Performance Springs
Fast 83LB Injectors
Complete Aeromotive Fuel System With Twin Pumps
MSD DIS 4 Ignition
MSD Tach Adapter
MSD 8.5 Plug Wires
MSD Blaster Coils
White Face Fuel and Boost Gauges
HBC Manuel Boost Controller
Mcleod Street Twin Clutch
PRO 5.0 Shifter
Built 8.8 Rear with 3.73 Gears
2.5” Catback H-Pipe Dynomac Muffler
Snow Performance Meth Injection
Car made 661/663 RWHP on pump gas at 17 PSI
I’m sure there are some things I missed, I have $18,000 in Receipts
Thing I know the car needs, Final Sanding and Paint, New Top, Bushings in Rear Lower control Arms
$18,000 OR TRADE
I will add Pics and Dyno Sheet this afternoon....thanks Mike
__________________
Car had been in an Accident when I purchased it about Three months ago, The pervious owner had it stored in his Garage when a drunk driver run into his house and into the garage Damaging the car on the driver side, I have replaced the drivers side Fender, Door, and Rear Quarter Panel, There was no structural damage under these panels so it was a pretty simple fix. There was also minor damage to the passenger side Fender and Door that has also been repaired.
MODS
HP Twin Turbo Kit
57 MM turbo up grade
Tial Waste Gate up grade
Tubular K-Member
Tubular Upper & Lower Control Arms
QA1 Caster/Camber Plates
QA1 Coilovers Front and Rear
MMR short block: Bore 3.552, Manley 18cc Dish 2618 Platinum Coated Pistons, ARP Stud Kit, Iron Block Good to 900 HP
Stage 1 Port Job
High Performance Springs
Fast 83LB Injectors
Complete Aeromotive Fuel System With Twin Pumps
MSD DIS 4 Ignition
MSD Tach Adapter
MSD 8.5 Plug Wires
MSD Blaster Coils
White Face Fuel and Boost Gauges
HBC Manuel Boost Controller
Mcleod Street Twin Clutch
PRO 5.0 Shifter
Built 8.8 Rear with 3.73 Gears
2.5” Catback H-Pipe Dynomac Muffler
Snow Performance Meth Injection
Car made 661/663 RWHP on pump gas at 17 PSI
I’m sure there are some things I missed, I have $18,000 in Receipts
Thing I know the car needs, Final Sanding and Paint, New Top, Bushings in Rear Lower control Arms
$18,000 OR TRADE
I will add Pics and Dyno Sheet this afternoon....thanks Mike
__________________
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
