611rwhp 534ftlb - all motor LS7
I made a little "ride along" video for general viewing pleasure.
Ignore the slow-poke granny shifting - we are working on figuring out of there is a hydraulic issue or a tranny issue - but suffice it to say, the bastard won't allow any fater shifting at the moment.
http://www.youtube.com/watch?v=UHC7ti8mFBA
Ignore the slow-poke granny shifting - we are working on figuring out of there is a hydraulic issue or a tranny issue - but suffice it to say, the bastard won't allow any fater shifting at the moment.
http://www.youtube.com/watch?v=UHC7ti8mFBA
Thread Starter
Staging Lane
Joined: Apr 2007
Posts: 80
Likes: 1
The current setup is Kooks 1 7/8 3" midpipe, Borla XR-1 resonator (it necks down to 2.5" then into the muffler) then Borla XR-1 tail pipes that are 3" over the axle pipes.
This seems to be the best compromise for nice sound, not so loud as to call all cops, and free flowing enough for good numbers.
If I could, I would run the full 3" open system all the time, but when your car sets off car alarms on the street behind your house when you start it up - you know your car is too loud
Its almost as if the clutch hydraulics dont always work - like I am not pushing the pedal all the way to the florr, but I am.
Farging GM hydraulics.
Last edited by RC45; Apr 13, 2008 at 02:01 PM.
I do believe they are Ferrea S99101's - good for .700 lift - they needed some other titanium bits I believe.
The current setup is Kooks 1 7/8 3" midpipe, Borla XR-1 resonator (it necks down to 2.5" then into the muffler) then Borla XR-1 tail pipes that are 3" over the axle pipes.
This seems to be the best compromise for nice sound, not so loud as to call all cops, and free flowing enough for good numbers.
If I could, I would run the full 3" open system all the time, but when your car sets off car alarms on the street behind your house when you start it up - you know your car is too loud
Thanks, yeah - it is almost a double clutch manouvre but all that really is needed is for the motor to lose some revs than I can shift.
Its almost as if the clutch hydraulics dont always work - like I am not pushing the pedal all the way to the florr, but I am.
Farging GM hydraulics.
The current setup is Kooks 1 7/8 3" midpipe, Borla XR-1 resonator (it necks down to 2.5" then into the muffler) then Borla XR-1 tail pipes that are 3" over the axle pipes.
This seems to be the best compromise for nice sound, not so loud as to call all cops, and free flowing enough for good numbers.
If I could, I would run the full 3" open system all the time, but when your car sets off car alarms on the street behind your house when you start it up - you know your car is too loud
Thanks, yeah - it is almost a double clutch manouvre but all that really is needed is for the motor to lose some revs than I can shift.
Its almost as if the clutch hydraulics dont always work - like I am not pushing the pedal all the way to the florr, but I am.
Farging GM hydraulics.
Thats when a turbo kit is nice to have since the turbo actually acts as a resonator before the muffler no cats needed. Then you add a cutout into the picture and wa la. BTW your ls7 setup is the cream of the crop as far as NA.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Topdon ONE vs. Artidiag 800 BT2: Which is the Diagnostic Tablet For You?
Pouria Savadkouei
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Launching!
Joined: Jan 2008
Posts: 233
Likes: 0
From: unknown
Make more videos. like hearing the car from the outside on the street. what it sounds like pully away at normal and wide open and drive bys. that video you have of the car on the cirvut track sounds like a nascar.
beautiful power curve(s), over 600whp from 6-7k - that is badass. that car will scoot no matter what track you put it on.
what would be had (or lost) by using a single plane intake? it seems high rpm power would rise and tq would decrease. that is definately an engine that needs to breathe.
what would be had (or lost) by using a single plane intake? it seems high rpm power would rise and tq would decrease. that is definately an engine that needs to breathe.
Thread Starter
Staging Lane
Joined: Apr 2007
Posts: 80
Likes: 1
The car is wicked wicked fast, so fast that I am fitting C6 Z06 six pistons pots up front with 2 piece light weight rotors to get the "stopping power" up to par with the "going power"
Yessir - it is my own rendition of the C5R hehe.
CamZilla Ride Along
CamZilla Time Attack
